Chapter 31 Bandwidth Management
ZyWALL / USG (ZLD) CLI Reference Guide
211
[no] inbound-dscp-mark {<0..63> | class {af11 |
af12 | af13 | af21 | af22 | af23 | af31 | af32 |
af33 | af41 | af42 | af43 | cs0 | cs1 | cs2 |
cs3 | cs4 | cs5 | cs6 | cs7 | default | wmm_be0
| wmm_be24 | wmm_bk16 | wmm_bk8 | wmm_vi32 |
wmm_vi40 | wmm_vo48 | wmm_vo56}}
Sets the DSCP value to apply to the incoming packets that
match this policy.
default: to have the ZyWALL / USG set the DSCP value of
the packets to 0.
The no command resets the incoming DSCP code to the
default (preserve) and have the ZyWALL / USG keep the
packets’ original DSCP value.
[no] incoming-interface {interface
interface_name | trunk group_name}
Sets the source interface of the traffic to which this policy
applies.
interface_name: The name of the interface. This depends
on the ZyWALL / USG model. See Table 36 on page 85 for
detailed information about the interface name.
group_name: A descriptive name for the trunk. The name
cannot start with a number. This value is case-sensitive.
The no command resets the incoming interface to the
default (any).
[no] log [alert] Sets the ZyWALL / USG to generate a log (and alert) for
packets that match the policy.
The no command sets the ZyWALL / USG to not generate a
log and alert for packets that match the policy.
[no] outbound ceiling {<0..1048576> | maximize-
bandwidth-usage}
Sets the maximum bandwidth allowed for outgoing traffic
or enables maximize bandwidth usage to let the traffic
matching this policy “borrow” any unused bandwidth on the
out-going interface.
The no command resets the outbound maximum bandwidth
to the default (0).
[no] outbound guarantee-bandwidth <0..1048576>
priority <1..7>
Sets how much outbound bandwidth, in kilobits per second,
this policy allows the traffic to use and also sets a number
between 1 and 7 to set the priority for traffic that matches
this policy. The smaller the number, the higher the priority.
Outbound refers to the traffic the UAG sends out from a
connection’s initiator.
The no command resets the outbound guarantee
bandwidth to the default (0).
[no] outbound-dscp-mark {<0..63> | class {af11 |
af12 | af13 | af21 | af22 | af23 | af31 | af32 |
af33 | af41 | af42 | af43 | cs0 | cs1 | cs2 |
cs3 | cs4 | cs5 | cs6 | cs7 | default | wmm_be0
| wmm_be24 | wmm_bk16 | wmm_bk8 | wmm_vi32 |
wmm_vi40 | wmm_vo48 | wmm_vo56}}
Sets the DSCP value to apply to the outgoing packets that
match this policy.
default: to have the ZyWALL / USG set the DSCP value of
the packets to 0.
The no command resets the outgoing DSCP code to the
default (preserve) and have the ZyWALL / USG keep the
packets’ original DSCP value.
Table 116 bwm Sub-commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
