ZyXEL Communications ZyWALL USG-Series - Page 287

Chapter 42 Services
ZyWALL / USG (ZLD) CLI Reference Guide
287
42.2.2.1 Service Group Command Examples
The following commands create service ICMP_ECHO, create service group SG1, and add
ICMP_ECHO to SG1.
[no] object-group group_name Adds the specified service group (second group_name) to the specified
service group (first group_name). The
no command removes the specified
service group from the specified service group.
[no] description description Sets the description to the specified value. The
no command removes the
description.
description: You can use alphanumeric and
()+/:=?!*#@$_%-
characters, and it can be up to 60 characters long.
object-group service rename group_name
group_name
Renames the specified service group from the first group_name to the
second group_name.
Table 171 object-group Commands: Service Groups (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# service-object ICMP_ECHO icmp echo
Router(config)# object-group service SG1
Router(group-service)# service-object ICMP_ECHO
Router(group-service)# exit
Router(config)# show service-object ICMP_ECHO
Object name Protocol Minmum port Maxmum port Ref.
===========================================================================
ICMP_ECHO ICMP 8 8 1
Router(config)# show object-group service SG1
Object/Group name Type Reference
===========================================================================
ICMP_ECHO Object 1