ZyXEL Communications ZyWALL USG-Series - Page 78

Chapter 11 Wireless Load Balancing
ZyWALL / USG (ZLD) CLI Reference Guide
78
The following example shows you how to configure AP load balancing in "by traffic" mode. The
traffic level is set to low, and "disassociate station" is enabled.
Router(config)# load-balancing mode traffic
Router(config)# load-balancing traffic level low
Router(config)# load-balancing kickout
Router(config)# show load-balancing config
load balancing config:
Activate: yes
Kickout: yes
Mode: traffic
Max-sta: 1
Traffic-level: low
Alpha: 5
Beta: 10
Sigma: 60
Timeout: 20
LIInterval: 10
KickoutInterval: 20