Dynamic IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DCHP ON):
1. Press and hold the RESET (p. 7) button.
2. Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be
heard (approx. 15–35 s).
3. Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
4. Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard
(approx. for another 3 s).
5. Release the RESET button.
Factory Default Reset
Reset the device factory default values via software in System > Maintenance (p. 48) Default reset.
Reset the device factory default values via software in System > Maintenance (p. 48) Default reset.
Factory Default Reset
1. Press and hold the RESET (p. 7) button.
2. Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be
heard (approx. 15–35 s).
3. Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
4. Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard
(approx. for another 3 s).
5. Wait until the red LED goes off and the acoustic signal can be heard (approx. for another 3 s).
6. Release the RESET button.
Brief Guidelines
20
To Next Page
Loading...
