• Preferred SIP Account – SIP account 1 or 2 is primarily used for calling.
• Call Encryption – set mandatory call encryption or no encryption.
• Door Opening – via callbacks.
Individual Ringtone – set an individual ringtone for specific contacts for better distinction.
Enable External Intercom Camera Display – set whether or not an external camera is available at the
contact terminal equipment (accordingly, the internal/external camera button is/is not displayed during calls
and call previews). With some 2N terminal equipment in the LAN, the information sent by the 2N terminal
equipment is preferred to this setting (i.e. this setting is not needed for contacts using 2N terminals or
camera-less devices).
Face Zooming Button – set whether or not the contact’s terminal device is able to monitor faces during
video calls (accordingly, the face monitoring button is/is not displayed during calls and call previews). With
some 2N terminal equipment in the LAN, the information sent by the 2N terminal equipment is preferred to
this setting (i.e. this setting is not needed for contacts using 2N terminals or camera-less devices).
Display
Display Device – display this device. The user can select and call for any device displayed.
Display on Top – display the device on the top.
Alternative Name – display an alternative name instead of the device name. If no alternative name is
entered, this is shown on the display.
NOTE
The <, > and / characters are not permitted for the parameters Device name and Alternative
name.
Call Button Function
Start Call with Short Press – a phone call to device A will be set up after a short press of the call button.
Alarm Call
Start Call with Doorbell Button Press – a phone call to this device will be set up after the alarm call button
is pressed. Set the doorbell alarm call function in Hardware > Digital inputs (p. 42) > Doorbell button.
Unlock Button Function
Name – enter the code assigned to unlock button.
Lift – select the door lock / lift lock button icon on the display.
Unlock Code – It is used for remote unlocking of the entrance door, for example. Make sure that the code
includes at least two door unlocking characters via the intercom keypad and at least one door unlocking
DTMF character via a phone. The supported characters also include * or #. Four characters at least are
recommended.
Time Profiles
Assign a Time profile to the DND mode to define when the selected function is available and when it is not.
Each time profile defines the function availability based on a week calendar. Just set From-To and/or specify
the weekdays for availability. 2N devices helps you create up to 20 time profiles (depending on the model)
The selected function can be assigned any time profile created in Calls > General settings (p. 32) >
Incoming calls.
Software Configuration
31
To Next Page
Loading...
