Mechanical Installation
This subsection provides the 2N Indoor Compact installation and connection instructions.
The device can be installed on any of the following ways:
•
into a wall using a mounting box (not included in the package),
•
onto a wall using a mounting box (not included in the package),
•
into a stand (not included in the package).
Installation Conditions
•
Exceeding the allowed operating temperature may not affect the device immediately but leads to prema-
ture ageing and lower reliability. For the acceptable range of operating temperatures and relative humidity
values refer to S. Technical Parameters (p. 66).
•
Keep some free space above and below the device to allow air to flow and conduct heat away.
•
No strong electromagnetic radiance is allowed on the installation site.
•
Make sure that the VoIP connection is configured properly according to the SIP and other VoIP recommen-
dations.
•
It is recommended that the power adapter be connected to the mains via a UPS and reliable overvoltage
protection.
CAUTION
This device and its installation and configuration techniques are not intended for persons
with diminished physical, sensory or mental capacities or persons with limited experience
and knowledge unless expertly supervised or duly advised as to the use of this device by a
person responsible for their safety.
Wall Installation
2N Indoor Compact is designed for flush mounting (brick, plasterboard, wood). Use the flush mounting box
(Part No. 91378800), which is not included in the package. Alternatively, the product can be surface installed
in a wall box (Part No. 91378803) or mounted into a desk stand (Part No. 91378802).
Mechanical Installation
9
To Next Page
Loading...
