Time Format – set the time format to be displayed.
Enable Screen Lock – enable the screen lock in the Idle device mode. Enter the screen lock PIN to unlock
the user interface.
Screen Lock PIN – set the screen lock activation/deactivation code.
Display Setting Menu – display the Setting menu. Or, configure the device via the web and remote access.
Display Time in Idle Mode – allow the device to display time in the Idle mode.
When the Doorbell Button Function is set to Doorbell (refer to Digital Inputs (p. 42)), a bell activation
notification is displayed whenever the doorbell is pressed. If the Idle time transition timeout is ≤120 s, the
notification will be displayed for 120 seconds. If the Idle time transition timeout is >120 s, the home screen
will be displayed after the 120-second timeout until the device goes into the Idle mode.
Backlight
Display Backlight Intensity – set the backlight brightness level. Set the value as a percentage of the
maximum possible LED brightness.
Intensity Reduction in Idle Mode to – set the level of reduction of the backlight intensity if the device goes
into Idle mode.
Go to Idle Mode in – set the inactivity timeout after which the device switches to the Idle mode.
Button Backlight In Idle Mode – enable button backlight in the Idle mode too.
User Localization
Original language – download a localization file template for a translation of your own. It is an XML file
with all the texts to be displayed in English.
Custom language – remove , download and upload a localization file of your own.
Custom Language Upload
1. Download the original language file (English).
2. Modify the file using a text editor (replace the English texts with your own ones).
3. Upload the modified localization file back to the intercom.
4. Set Language to Custom (p. 41) in “Basic Settings”.
5. Check and correct if necessary the texts on the intercom display.
Digital Inputs
The Digital Inputs menu describes the digital input options for the device.
Doorbell Button
Doorbell Button Function – select a doorbell function (doorbell, alarm call). The button is used either as a
classical doorbell or for alarm call activation.
System
Network
2N Indoor Compact is connected to the LAN and has to be assigned a valid IP address or obtain the IP
address from the LAN DCHP server. The Network section helps you configure the IP address and DHCP.
Software Configuration
42
To Next Page
Loading...
