2N Indoor Compact - Page 43

TIP
To retrieve the IP address, use 2N Network Scanner, which can be downloaded freely from
2N.com. Refer to Subs. IP Address Retrieval Using 2N Network Scanner (p. 21) for details.
If the network uses the RADIUS server and 802.1x-based verification of connected equipment, you can
make the intercom use the EAP-MD5 or EAP-TLS authentication. Set this function in 802.1x (p. 43).
Basic
Use DHCP server – enable automatic obtaining of the IP address from the LAN DHCP server. If no DHCP
server is existing or available in the network, set the network manually.
Static IP Address Setting
Static IP Address – static IP address of the device. The address is used together with the below mentioned
parameters if the Use DHCP Server parameter is disabled.
Network Mask – network mask setting.
Default Gateway – default gateway address for off-LAN communication.
DNS Setting
Always Use Manual Setting – enable manual setting of the DNS server addresses.
Primary DNS – primary DNS address for domain name-to-IP address translation.
Secondary DNS – secondary DNS address where the primary DNS is unavailable.
Network Identification
Hostname – set the device LAN identification.
Vendor Class Identifier – set the manufacturer identifier as a character string for DHCP Option 60.
VLAN Settings
VLAN Enabled – enable the virtual network support (VLAN according to 802.1q). Remember to set the
VLAN ID too.
VLAN ID – choose a VLAN ID from the range of 1–4094. The device shall only receive packets with the set
ID. An incorrect setting may result in a connection loss and subsequent factory reset (p. 20).
Network Interface Settings
Required Port Mode – set the LAN port mode to be preferred: Automatic or Half Duplex – 10 Mbps. The bit
rate is reduced to 10 Mbps in case the available LAN cabling is unreliable for a 100 Mbps traffic.
Offered Modes – select the modes to be advertised in autonegotiation.
Current Port State – current LAN port state: Half or Full Duplex – 10 Mbps or 100 Mbps.
802.1x
Device Identity
Device identity – username (identity) for authentication via EAP-MD5 and EAP-TLS.
MD5 Authentication
Authentication enabled – enable network device authentication via the 802.1x EAP-MD5 protocol. If the
network does not support 802.1x, the intercom will become unavailable.
Password – enter the access password for EAP-MD5 authentication.
Software Configuration
43