User Localization
Original Language – download an original XML file from the device including all user interface texts in
English.
User Language – upload , download and/or remove user files including translations of the
user interface texts.
Hardware
Audio
2N Indoor Compact is equipped with a speaker. Set the phone call and state signaling volume control in this
configuration section.
Phone Call Volume
Call Volume – set the phone call volume.
Ringtone Volume – set the volume of the incoming call ringtone. The value is relative to the master volume.
Call Progress Tone Volume – set the dialtone, ringtone and busy tone volume levels. In case the call
progress tones are automatically generated by the PBX, this setting will not be applied.
Signaling Volume
Button Press Volume – set the Button Press Volume. The volume values are relative against the set master
volume.
Warning Tone Volume – set the volume of warning and signaling tones described in the Signaling of
Operational Statuses section. The value is relative to the master volume.
Suppress Warning Tones – suppress signaling of the following operational states: Internal application
started, IP address received and IP address lost.
User Sound Volume – set the volume of user sounds played by automation. The value is relative to the
master volume.
Camera
2N Indoor Compacthelps you configure up to 16 external cameras for video call streaming.
NOTE
The 2N answering units receive standard external IP cameras supporting the RTSP streams
meeting the following limits:
• codec H.264 or MJPEG
• 1280x720 px resolution
• maximum framerate of 30 FPS for H.264 or 15 FPS for MJPEG. Higher frame rates may
result in undesired effects (less smooth playing).
• High profile with 5000 kbps bitrate if codec H.264 is used
Camera enabled – enable RTSP stream download from an external IP camera. Complete the valid RTSP
stream address or the username and password to make the function work properly.
Software Configuration
39
To Next Page
Loading...
