Camera Assignment
Click to open the device list and select the devices to which a camera is to be assigned. In the call
with the device to which the camera is assigned, it is possible to show the selected camera preview on the
answering unit and switch it to previews of other assigned and allowed cameras.
Click to cancel all assignments of the selected camera.
TIP
Cameras can also be assigned to devices in respective device settings in the Directory >
section Device (p. 27). Once saved, the change will automatically be written in both the
sections.
Settings
Display Name – set the name to be displayed at the camera preview in the directory on the device. If the
parameter is empty, the default name set for the selected language is displayed.
RTSP Stream Address – enter the IP camera RTSP stream IP address: “rtsp://camera_ip_address/param-
eter1=value&parameter2=value”, refer to the parameter table below. The parameters are specific for
the selected IP camera model. If you choose another 2N IP intercom for the external camera, enter “ http://
ip_address/mjpeg_stream” or “http://ip_address/h264_stream”.
TIP
To connect stream from a camera of another 2N device, copy the Local URL of the stream
of the given device from Services > ONVIF/RSTP.
Software Configuration
40
To Next Page
Loading...
