All applicable legal regulations concerning the product installation and use as well as provisions of technical
standards on electric installations have to be obeyed. The manufacturer shall not be liable and responsible
for damage or destruction of the product or damage incurred by the consumer in case the product is used
and handled contrary to the said regulations and provisions.
The consumer shall, at its own expense, procure software protection of the product. The manufacturer shall
not be held liable for any damage incurred as a result of the use of deficient security software.
The consumer shall, without delay, change the access password for the product after installation. The
manufacturer shall not be held liable or responsible for any damage incurred in connection with the use of
the original password.
The manufacturer also assumes no responsibility for additional costs incurred by the consumer as a result of
making calls to increased tariff lines.
Requirements for compliance with UL 294
This section contains information and instructions required for UL compliance. To make sure the installation
is UL compliant, follow the instructions below in addition to the general information and instructions provided
throughout this document. In cases where pieces of information contradict each other, the requirements for
UL compliance always replace general information and instructions.
Performance levels for access control:
This section contains performance level information required for UL 294 compliance.
Feature Level
Destructive attack test I
Security I
Endurance IV
Standby power I
Safety instructions:
•
Shall be installed in accordance with Article 725.121 of the National Electrical Code, ANSI/NFPA 70.
•
The 2N product shall be installed and serviced by a factory trained professional.
•
All interconnecting devices shall be UL listed and Class 2 low-voltage power limited.
•
All power outputs are Class 2 outputs.
•
All wiring methods shall be performed in accordance with ANSI/NFPA70, local codes and authorities
having jurisdiction.
•
The wiring of the door relay is limited only inside of the protected area.
•
When the 2N product has reached the end of its useful life, dispose of it according to local laws and
regulations. The product should not be disposed of together with household or commercial waste.
Specifications:
Directives, Laws and Regulations - General Instructions and Cautions
71
To Next Page
Loading...
