3D Systems ProX DMP 200 - Page 50

463D SYSTEMS, INC.
3
Information area
• ATMOSPHERE
• Gas (mode of the gas supplied): REGUL (regulation around an oxygen target value), DIRECT (continuous injection of
gas at a constant rate), OFF (no gas injection),
• Status of the gas valve indicator : if green, the valve is opened,
• O2 value: current oxygen level value in PPM (particles per million) on the manufacturing chamber,
• O2 setpoint: oxygen level target value,
• Enclosure pressure: current pressure value in the manufacturing chamber,
• Enclosure temperature: current temperature value on the manufacturing chamber.
• LENS CLEANER
• Turbine: state of the lens cleaner blower (turbine). If green/white, the blower is operating/not operating,
• Setpoint: setpoint of the blower operating, in %,
• Differential pressure : [Outlet Pressure – Inlet Pressure] of the external lter.
• PART
• Clamping: status of the base plate clamp. If green/white, clamping is ON/OFF,
• Available powder: the height of the powder available in the feeding piston in mm,
• Zero sintering: the zero position of the sintering piston in mm.
• Loaded powder: name of the powder. Corresponds to the value set in the Conguration menu (see section
"Conguration" on page 47).
• LASER/OPTIC
• Defocus: defocusing value in mm (relative position of the sintering piston compare to the zero sintering position),
• Laser power: current Laser power, in %.