3D Systems ProX DMP 200 - Page 55

513D SYSTEMS, INC.
Event browser
The Event browser tool is composed of 4 tabs:
• Version tab
It lists the different software versions and when they have been installed.
• Manufacturing tracking tab
Each event occured during a preparation or a job is traced and stored on a tracking le. Each time a new sintering plate is
loaded into the printer, a tracking le is created. As long as a tracking le is existing on the printer, it can be viewed and
exported.
When the plate is unloaded, its tracking plate le will be closed.
The format of the tracking le is ".xml", and is composed by: PrinterType_SerialNumber_PlateNumber
• Printer type (e.g ProX DMP200)
• Serial number (e.g 1122333)
• Plate number: the number entered during the plate loading (see section "Step 4 : Zero sintering" on page 37) is
linked to the name of the corresponding tracking le
1. Click on the "Open le" button to open a
tracking le (A).
2. Select the desired tracking le from the list.
3. All corresponding events will be indicated on
the information area (B).
4. Optional: use the "Information lter" (C)
to select an event type (Preparation or
Manufacturing).
5. Optional: use the "+" or "-" buttons (D) to
directly open/close all navigation trees.
6. Export functions (E): to export the tracking le
("csv", "xml" or "pdf" formats).
7. The export button (F) creates a manufacturing
report in "pdf" format (see example
"Manufacturing report" on page 51).
B
A
C
D
E
F