4.3. Choosing the right site for installation
Device installation site should meet the following requirements:
• the device should operate at room temperature,
• the device is not suitable for operating in dusty environments,
• provide a room ventilation adequate to its size,
• the device should be located on a solid, stable ground, capable of long-term bearing of the device work load,
• provide sufcient amount of free space by taking into account device outer dimensions (g. 6 and 7);
provide access from all sides of the printer for maintenance,
• the device should be kept away from other heat sources, direct and long-term exposure to sunlight should
be avoided,
• installation site should be equipped with a mains socket rated 240 V ~ 6A, 50/60 Hz,
• it is recommended to use a UPS to prevent from interrupting printing process in the event of temporary
power failure.
Fig. 6. Maximum dimensions of 3DGence INDUSTRY F340 printer – front view.
Fig. 7. Maximum dimensions of 3DGence INDUSTRY F340 printer – top view.
To Next Page
