3DGence INDUSTRY F340 - I INTRODUCTION; 1. Introductory Comments; 2. Printing Materials

6 | 3DGence INDUSTRY F340
I INTRODUCTION
1. INTRODUCTORY COMMENTS
2. PRINTING MATERIALS
The FFF (Fused Filament Fabrication) technology used by the 3DGence INDUSTRY F340 printer consists in applying plas-
ticized material layer by layer. This plastic material is a consumable of the printer. It has the form of a plastic lament
(wire, string) of a specic diameter which is wound on a spool (g. 1). 3DGence INDUSTRY F340 uses 1.75 mm diameter
lament only.
Fig. 1. Material spool.
Thank you for choosing a printer supplied by 3DGence INDUSTRY F340. This manual will provide a clear and legible de-
scription of this professional 3D printer allowing you to obtain optimum performance as well as repeatable, safe and
long-lasting operation. The mission of 3DGence is to offer only top professional devices and solutions.
This manual includes information necessary to ensure correct and safe operation. Prior to using the device, it is neces-
sary to read and understand the whole content of this manual. A supplemental document to this manual is avaiable on
the website.
It is forbidden to use the printer by people who have not read the manual. Any misuse can lead to device damage, body
injuries or even endanger operator’s life.
At the end of this manual you can nd a glossary for terms and concepts related to 3D printing. It will facilitate under-
standing professional terms and will explain some of the notions used in this manual.
Using the 3DGence INDUSTRY F340 printer means that you have fully read and understood the manual and accept its
guidelines and exceptions as well as fully accept warranty terms and conditions. A warranty card is attached to the
device.