3DGence INDUSTRY F340 - Default Chapter; Table of Contents

3DGence INDUSTRY F340 | 3
version 1.0/07.2017
I INTRODUCTION
1. Introductory comments
2. Printing materials
3. Warning signs
3.1. Auxiliary symbols used in this manual
4. Safety precautions
4.1. General information
4.2. Carrying the device
4.3. Choosing the right site for installation
4.3.1. Connection specications
4.4. Prior to startup
II DEVICE DESCRIPTION
1. Printer construction
1.1. Outline
1.2. Kinematic system
1.3. Printing bed
1.4. Filament chamber
1.4.1. Filament chamber temperature adjustment
1.5. Extruder chamber
1.6. Dual-head module
1.7. Power supply management
1.7.1. Master switch
1.7.2. Printer power switch
1.7.3. Emergency stop button
1.8. Memory card
1.9. Smart Material Manager System
2. Set composition
3. User interface
3.1. Standby menu
3.2. Menu during operation
4. Menu structure
III PREPARING TO OPERATION
1. Installing 3DGence Slicer
1.1. Updating rmware
2. Connectingand turning the printer on
3. Preparing the operating platform
3.1. Calibrating the working area
4. Handling the material
4.1. Installing the material
4.1.1. Material installation is unsuccessful
4.2. Removing the material
6
6
6
7
8
8
8
9
11
12
12
13
13
13
20
20
21
21
22
22
23
23
23
24
25
25
25
25
26
36
38
44
44
44
44
46
46
47
47
49
49