1.8. Memory card
The 3DGence INDUSTRY printer supports SDHC Class 10 memory cards. Lower class SD memory card may slow down
the device operation or generate errors. The card capacity should not exceed 8 GB.
1.9. Smart Material Manager System
Smart Material Manager system is used to control and monitor materials installed. It is designed to determine:
• material net weight,
• material type,
• material color,
• printer working parameters for each lament,
• spool weight.
The system consists of three key components:
1. An NFC reader located on the right device wall:
2. An NFC sticker located on the material spool coming from the Base of Certied Materials.
3. Scales installed in material holders.
For more information on operating SMM system refer to OPERATING THE DEVICE, section 4.
2. SET COMPOSITION
The 3DGence INDUSTRY F340 comes with a supply of consumables and a set of necessary accessories. The set consists of:
• 3DGence Slicer,
• 6 kilograms of ABS lament,
• 4 kilograms of HIPS supporting material,
• spatula for removing prints,
• tweezers,
• protective gloves,
• SDHC Class 10 memory card,
• pendrive portable memory,
• Dimax adhesion spray,
• 8 pneumatic ttings,
• set of spare PTFE Bowden tubes,
• USB cable.
3. USER INTERFACE
3DGence INDUSTRY F340 printer is equipped with a 5-inch color, touch screen, located on the left of its front wall. It
makes an interface for providing communication with the device by using a clear graphical menu. The device menu has
a different appearance depending on printer operating status (operation or standby).
The menu diagram is presented in section 4 of the DEVICE DESCRIPTION chapter.
To Next Page
Loading...
