Pannoramic SCAN II 2.2.0 User’s Guide 5.3.2 General functions at the magazine menu
5.3.2 General functions at the magazine menu
Rack view mode selector
Switch view by clicking the button. Click to add a virtual magazine to the planner, and to
remove a magazine from the planner.
Profile management for selected magazine includes the following global settings applicable to
all magazines:
• Add current profile for all slides
• Open profile to all slides
• Detach current profile from all slides
• Detach profiles from slides
• Clear all slide results
5.3.3 General functions at the slide menu
• Mark empty slide positions – Define range in the Range to skip boxes to set multiple slide
positions as empty. For a single slide, enter / set slide position with the arrows in the Range
to skip box or right-click on a slide and select Skip.
Figure 71 – General functions at the slide menu
• Click Reset at the Slides settings bar to cancel slide selections as empty, or right-click the
thumbnail of a slide selected as skipped and click Reset.
• You can apply a selected profile to a defined range of slides at the Profile range section. Set
the slide positions within the range (first and last slide) then click .
January 24, 2020 - Rev. 2 3DHISTECH Ltd. 104(156)
To Next Page
