3DHISTECH Pannoramic SCAN II - Using Profiles

Pannoramic SCAN II 2.2.0 User’s Guide 5.8 Using Profiles
5.8 Using Profiles
Note:
Saved profile settings cannot be applied if using a different type of
Pannoramic® scanner.
If you want to scan a group of slides, it is advised to save your settings previously in a profile and
continue scanning in Automatic mode. You can save the following settings in a profile:
Scan Mode
• Brightfield
• Fluorescent
Scan Options
• Focus frequency (in Fluorescent mode)
• Focus frequency (in Brightfield mode)
• Compression procedure
• Use of a fixed compensation image (in Brightfield mode – ON/OFF)
• Use of Save focus quality (ON/OFF)
• Use of stitching (ON/OFF)
Determination of the area to be scanned
• Use of automatic threshold specimen
• Use of specimen threshold value
• Use of marker pen threshold and specimen threshold values
• Use of scan everything within marked area (ON/OFF)
• Remove coverslip function (ON/OFF)
• Filling of holes (ON/OFF)
• Use of removing specks according to the set value (ON/OFF)
January 24, 2020 - Rev. 2 3DHISTECH Ltd. 131(156)