Pannoramic SCAN II 2.2.0 User’s Guide 6 Troubleshooting and Maintenance
6 Troubleshooting and Maintenance
6.1 Recovery functions
PSW automated backups allow you to continue scanning after unexpected events within as little time
as possible. After the program is restarted and the microscope is initialized, you can confirm the
automatic restore of pre-event state by clicking Yes.
Warning!
Click Yes only if you are absolutely sure that everything is completely
unchanged after the previous run. If anything has changed or you are
unsure, click No.
For more comfortable and safer use, the Planner autosave function allows the taking of automatic
backups while creating a scan plan. The backups are placed in the default document folder of the
actual windows user and can be loaded by clicking the Load plan button.
6.2 Safety Information
Check cables, plugs and connections before operation, and if defective or cannot be replaced, contact
3DHISTECH Service for support.
Check whether the device is compatible with your local line voltage. It can operate at line voltages
100V to 240V and 50/60 Hz.
Only plug the device in a socket with protective grounding (earth) contact.
Do not operate the device in explosive environment.
Disconnect the device from the power outlet before opening it or replacing a part.
The product is not equipped with protection against hazardous materials (infectious, toxic,
radioactive, corrosive substances or other effects damaging to health). Decontaminate infectious
materials after use.
January 24, 2020 - Rev. 2 3DHISTECH Ltd. 133(156)
To Next Page
Loading...
Need help?
General
