3M Dynatel 2250M - Modifying Marker Data to be Written

78-8130-6150-0-F 47
− Thereceiverwillaskiftheuserwantsto
permanentlylockthemarkerdata.
9. SelectNo [SK]orYes[SK].Thereceiverwill
writethedatatothemarker.(See note below.)
10. AfterwritingtotheiDMarkeriscompleted,the
followingwillbedisplayed.
Note: Once the marker data has been locked, the information contained on the marker
is PERMANENT. Choosing to permanently lock the marker data is irreversible. Once
the data is locked it can not be overwritten. Assure that the data that is being written is
correct before proceeding.
A. Modifying Marker Data to be Written
Toaltertheinformationtobewrittenintothemarker
1. PressMenu[6]+Write Mode [SK:1].
2. Selectatemplatefromthelistonthedisplaytobewrittenintothemarkerby
pressingtheup/downarrows[SK]tohighlightthepreferredtemplate.‘Last
Written/Read’isthemostrecentdatathatwaswrittentoamarkerbythereceiver.
3. PressView/Edit[SK].
4. Presstheup/downarrows[SK]tohighlightthe
informationtochange.
5. PressModify[SK].Thepercentagedisplayedin
theupperrightportionofthedisplayindicates
theremainingmemoryavailableonthemarker.