3M Dynatel 2250M - Quick Start; Transmitter Battery Installation

 8 78-8130-6150-0-F
3. Quick Start
A. Transmitter Battery Installation
Loosenthesixscrewsonthebatterycompartmentcoveronthebottomofthetransmitter.
Removethecover.
Installsix‘C’sizealkalinecellbatteries(LR14)intothecompartmentasindicatedby
thepolaritysymbols(+and–).
Replacethecoverandtightenthescrews.
PressandholdOFF[T-1]tomanuallytestthebatteries.Thedisplayandaudiowill
indicateoneofthefollowinglevels:(OKw/solidtone=good;LOw/beepingtone=
low;"--"w/notone=replace)
m Caution
To reduce the risks associated with fire and explosion:
• Do not short, excessively heat, or dispose of batteries in fire.
• Install batteries with proper polarity.
• Use only Alkaline "C" (LR14) sized batteries.
• Do not charge batteries
• Do not use leaking batteries
To reduce the risks associated with environmental contamination:
• Dispose of batteries and electronic components in accordance with all regulations.
• Ensure batteries are installed with correct polarity.
• Always remove batteries when storing the units for long periods of time.
6 'C' (LR14) size
Alkaline Batteries