3M Dynatel 2250M - Safety Information; Intended Use

 6 78-8130-6150-0-F
1. Safety Information
Pleaseread,understandandfollowallsafetyinformationcontainedintheseinstructions
priortotheuseofthe3MCable/Pipe/FaultAdvancedM-SeriesLocator.Retainthese
instructionsforfuturereference.
A. Intended Use
The3MCable/Pipe/FaultAdvancedM-SeriesLocatorisusedtoidentifytheplacement
ofundergroundutilitylines.Thesystemmustbeinstalledasspecifiedinthe3MCable/
Pipe/FaultAdvancedLocator2250M/2273MSeriesOperatorManual.Ithasnotbeen
evaluatedforotherusesorlocations.Ifthisequipmentisusedinamannernotspecified
by3M,theprotectionsprovidedbytheequipmentmaybeimpaired.
m WARNING
If this equipment is used in a manner not specified by 3M, the protections provided by the
equipment may be impaired.
Explanation of Signal Word Consequences
m Warning:
Indicates hazardous situation which if not avoided, could result in
death or serious injury.
m Caution:
Indicates hazardous situation which if not avoided, could result in
minor or moderate injury.
Explanation of Product Safety Label Symbols
Do not throw away in normal trash.
c
Warning: Risk of electric shock
m WARNING
This WARNING applies to the following 3M Dyna-Couplers;
• 3" (75 mm) - Part number 3001
• 4.5" (114 mm) - Part number 4001
• 6" (150 mm) - Part number 1196
• All accessory kits containing any of the listed Dyna-Couplers - Part numbers 3019, 4519,
1196/C
A potential for electrical shock exists when using the Dyna-Coupler on cables energized with
electrical power. Use appropriate safety procedures.
DO NOT USE ON CABLES CARRYING IN EXCESS OF 600 VOLTS RMS.