ABB ACS880-14 - Installing the EMC Filter (Option +E202); Connecting the Power Cables

WARNING!
Do not install the drive with EMC filter option +E202 connected to a system that
the filter is not suitable for. This can cause danger, or damage the drive.
Note: When EMC filter +E202 is disconnected, the drive EMC compatibility is considerably
reduced.
WARNING! Do not install the drive with the ground-to-phase varistor connected
to a system that the varistor is not suitable for. If you do, the varistor circuit can
be damaged.
WARNING! Do not install the drive on a corner-grounded or midpoint-grounded
delta system. Disconnecting the EMC filter and ground-to-phase varistor does not
prevent damage to the drive.
Installing the EMC filter (option +E202)
See ARFI-10 EMC filter installation guide (3AFE 68317941 [English).
Connecting the power cables
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
Electrical installation 101
11