ABB ACS880-14 - Option Codes

DescriptionCode
When no options are selected: regenerative single drive module to be installed in an enclosure,
IP20 (UL Type Open), bookshelf mounting with pedestal, external control unit with ACS-AP-W As-
sistant control panel with Bluetooth interface and panel holder, build-in LCL filter, full-size output
cable connection terminals, no EMC filter, DC connection busbars, clear plastic shrouds for covering
the input power and motor cable connections, ACS880 primary control program, Safe torque off
function, coated boards, printed multilingual quick installation and start-up guides, extraction/install-
ation ramp.
-14
Size
See the ratings table.-xxxxA
Voltage range
380…415 V AC. This is indicated in the type designation label as typical input voltage level
(3~ 400 V AC)
-3
380…500 V AC. This is indicated in the type designation label as typical input voltage levels
(3~ 400/480/500 V AC)
-5
525…690 V AC. This is indicated in the type designation label as typical input voltage levels
(3~ 525/600/690 V AC)
-7
￭ Option codes
DescriptionCode
No IP20 shrouds for cabling area (Not to be used with option +H381)0B051
EMC filter for 1st environment TN (grounded) system, category C2. Available for ACS880-14-xxxx-
3 and -5 types only.
E202
Common mode filterE208
EMC filter for 2nd environment TN (grounded) or IT (ungrounded) system, category C3E210
No full size cable connection terminals for output power cables0H371
Full-size input terminalsH370
Full power cabling panels to be attached to a cabinet. The drive module can be pulled out from the
cabinet without disconnecting the power cables. IP20 degree of protection. Not to be used with
options +0B051 and +H370.
H381
No control panel0J400
DPMP-01 door mounting kitJ410
DPMP-02 door mounting kit (surface mounting) for the panelJ413
ACS-AP-I control panelJ425
FDNA-01 DeviceNet™ adapter moduleK451
FPBA-01 PROFIBUS DP adapter moduleK454
FCAN-01 CANopen adapter moduleK457
FSCA-01 RS-485 (Modbus/RTU) adapter moduleK458
FCNA-01 ControlNet™ adapter moduleK462
FECA-01 EtherCat adapter moduleK469
FEPL-02 EtherPOWERLINK adapter moduleK470
FENA-21 Ethernet adapter module for EtherNet/IP™, Modbus TCP and PROFINET IO protocols,
2-port
K475
FEIP-21 EtherNet/IP adapter moduleK490
FMBT-21 Modbus/TCP adapter moduleK491
42 Operation principle and hardware description