ABB ACS880-14 - Installing the Drive Module into the Enclosure

Installing the drive module into the enclosure
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
Handle the drive module carefully. Make sure that the module does not fall down when
moving it on the floor and during installation and maintenance work: Open the support legs
by pressing each leg a little down and turning it aside (1, 2). When ever possible secure the
module also with chains from top.
Do not tilt the drive module. It is heavy and its center of gravity is high. The module will
overturn from a sideways tilt of 5 degrees. Do not leave the module unattended on a sloping
floor.
1
2
3
3AUA0000086323
146 Installation example with full cabling panels (option +H381)