3 In the Controller tab, choose Visual SafeMove from the Safety group in the
Configuration category.
4 In the left pane of the window, choose Global_TSP under the Tool Speed
Supervisions from the navigation tree.
xx2200000438
5 In the Visual SafeMove Properties window, set the Max speed (mm/s) in
the Speed limits area to a required value.
xx2200000439
6 Apply the configuration to the controller by clicking Write to Controller in
the Controller group in the Configuration category.
Continues on next page
162 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
3 Installation and commissioning
3.7.7 Use cases of safety configurations
Continued
To Next Page
Loading...
