9.6 Standard toolkit
General
All service (repairs, maintenance, and installation) procedures contains lists of
tools required to perform the specified activity.
All special tools required are listed directly in the procedures while all the tools
that are considered standard are gathered in the standard toolkit and defined in
the following table.
This way, the tools required are the sum of the standard toolkit and any tools listed
in the instruction.
Contents, standard toolkit
Rem.ToolQty
Ring-open-end spanner 8-19 mm1
Socket head cap 2.5-17 mm1
Torx socket no: 20-601
Box spanner set1
Torque wrench 10-100 Nm1
Torque wrench 75-400 Nm1
Ratchet head for torque wrench 1/21
Hexagon-headed screw M10x1002
Hexagon-headed screw M16x901
Hex head allen wrench drill bit set M2-M8 (φ 2.5 mm - φ
10 mm)
1
Plastic mallet1
716 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
9 Reference information
9.6 Standard toolkit
To Next Page
Loading...
