Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the CRB 1300 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Replace if damaged.3HAC064478-001Mechanical stop, axis 1, fixed block
Replace if damaged.3HAC065755-001Mechanical stop, axis 1, slider
Replace if damaged.3HAC065651-001Mechanical stop, block A
Used for axis 3 of CRB 1300-
10/1.15.
Replace if damaged.
3HAC065671-001Mechanical stop, block B
Replace if damaged.3HAC065805-001Mechanical stop, axis 4, flange
Replace if damaged.3HAC065804-001Mechanical stop, axis 4, slider
Required tools and equipment
Note
The axis-1 mechanical stops are accessible after removing the base, see
Replacing the base on page 260.
The axis-4 mechanical stops are accessible after removing the housing, see
Replacing the housing and extender unit on page 378.
Visual inspection, no tools are required.
Other tools and procedures may be required if the spare part needs to be replaced.
These are specified in the replacement procedure.
Inspecting mechanical stops
Use this procedure to inspect mechanical stops on axes 2 and 3.
InformationAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
1
See figures in Location of mechanical
stops on page 175.
Inspect the mechanical stops.2
Continues on next page
Product manual - CRB 1300 177
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
4 Maintenance
4.4.3 Inspecting mechanical stops
Continued
To Next Page
Loading...
