ABB CRB 1300 - Page 447

Separating the tubular
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
xx2000001739
Remove the tubular and tilt unit from the extender
unit.
2
Separating the tubular support
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
xx2000001740
Remove the tubular support.
Tip
If the tubular support is hard to loosen from the
tubular, use a plastic hammer to knock on the tu-
bular support lightly.
2
Separating the tilt unit
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
Continues on next page
Product manual - CRB 1300 447
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.3 Replacing the tubular and tilt unit
Continued