NoteAction
Lamp unit cover: 3HAC082320-001Refit the lamp unit cover.3
Screw: M3x8 12.9 Lafre
2C2B/FC6.9 (4 pcs)
Tightening torque: 0.6 Nm
xx2200001002
Reconnecting the air hoses and Ethernet cabling (if equipped)
NoteAction
xx2000001539
Reconnect the air hoses.
Note
See the number markings on the air hoses for
help to find the corresponding air hoses.
1
xx2200001001
For robots with Ethernet cabling
Access the connector from the process hub and
reconnect the connector.
• J1.C2
Tip
See the number markings on the connectors for
help to find the corresponding connector.
2
Refitting the axis-6 motor
NoteAction
Check that:
• all assembly surfaces are clean and without
damages
• the motor is clean and undamaged.
1
Continues on next page
Product manual - CRB 1300 459
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.3 Replacing the tubular and tilt unit
Continued
To Next Page
Loading...
