Refitting the axis-5 timing belt
NoteAction
xx2000001595
Install the timing belt to the pulleys and verify that
the belt runs correctly in the grooves of the pul-
leys.
1
Used belt: 59.3-63.4 HzMove the motor to achieve proper belt tension.2
New belt: 70.8-74.3 Hz
Use a sonic tension meter to measure the timing
belt tension.
3
If the timing belt tension does not meet the require-
ment, loosen the motor screws and readjust.
Tightening torque: 6 NmSecure the motor with the screws.4
xx2000001594
Reconnecting the CP/CS cabling (if equipped)
NoteAction
xx2000001537
Insert the male header of the connectors to the
connector plate.
1
Continues on next page
462 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.3 Replacing the tubular and tilt unit
Continued
To Next Page
Loading...
