ABB CRB 1300 - Page 587

NoteAction
Screw: M6x20 12.9 Gleitmo
603+Geomet 500 (4 pcs)
Refit the screws and washers.6
Tightening torque: 10 Nm
xx2000001626
Releasing the weight support for lower and upper arms
NoteAction
WARNING
Personnel must not, under any circumstances,
be present under the suspended load.
1
Make sure the lower and upper arms are firmly
secured with the swing.
2
Remove the roundslings.3
Securing the cable package in the swing
NoteAction
xx2000001746
Route the cable package up into the lower arm.
Make sure that the the air hoses are facing outside
in the axis-2 cable protector, see the figure as a
guidance for the cable twisting way.
1
Continues on next page
Product manual - CRB 1300 587
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.7.2 Replacing the axis-2 gearbox
Continued