NoteAction
xx2000001553
Remove the cable bracket from the lower arm first
and then from the cable package.
2
xx2100001465
Wrap the connectors with the masking tape.3
xx2000001662
Pull the cable package out to the lower arm sup-
port.
Note
During the routing, make sure the axis-2 motor
cablings are kept visible and accessible from the
lower arm support side.
4
Removing the lower arm support
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
xx2000001663
Remove the lower arm support.
Tip
If the lower arm support is hard to loosen from
the swing, use a plastic hammer to knock on the
lower arm support lightly.
2
Continues on next page
Product manual - CRB 1300 613
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.7.3 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
