NoteAction
Screw: M8x40 12.9 Gleitmo
603+Geomet 500 (7 pcs)
Refit the lower arm support.2
Tightening torque: 39 Nm
xx2000001663
Refitting the axis-3 timing belt
NoteAction
xx2000001615
Install the timing belt to the pulleys and verify that
the belt runs correctly in the grooves of the pul-
leys.
1
Used belt: 73.4-78.5 HzMove the motor to achieve proper belt tension.2
New belt: 87.8-92.1 Hz
Use a sonic tension meter to measure the timing
belt tension.
3
If the timing belt tension does not meet the require-
ment, loosen the motor screws and readjust.
Tightening torque: 3.3 NmSecure the motor with the screws.4
xx2000001614
Release the support to the upper arm.5
Continues on next page
620 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.7.3 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
