ABB CRB 1300 - Page 679

Spare parts
When calibration is not being performed, a protective cover and an o-ring should
always be installed on the fixed calibration pin as well as a protective plug, included
a sealing, in the bushing. Replace damaged parts with new.
NoteArticle numberSpare part
Replace if damaged or missing.3HAC053237-003Protective plug for 10-mm
bushing
Replace if damaged or missing.3HAC053237-002Protective plug for 12-mm
bushing
Replace if damaged or missing.3HAC056253-003Calibration pin cover, 10 mm
Replace if damaged or missing.3HAC056253-002Calibration pin cover, 14 mm
Replace if damaged or missing.3HAC061327-022O-ring on calibration pin
Replace if damaged or missing.3HAC061327-011O-ring on calibration pin
Product manual - CRB 1300 679
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
6 Calibration
6.4.3 Installation locations for the calibration tools
Continued