FSM4000 ELECTROMAGNETIC FLOWMETER | OI/FSM4000-EN REV. E 69
Submenu Select each different line displayed for the process indicators in
this submenu. You can also adapt the contrast of the display to
local conditions by pressing the arrow keys.
Display mode 1 big, 1 small,
4 small
Select 1 big and 1 small line or 4 small lines.
Q [percent]; Q [Unit];
Iout [mA]; Q [m/s]; Q
BargraphTotalizer;
Totalizer → V; Totalizer
← R; Totalizer Diff.; HART
TAGDetector l.pipe
Blank line
Additional selection for
extended diagnosis:
Fprt1; Fprt2; Fprt3;
Fprt4; Hist Max Error;
Hist Min Error;
Curr Max Error;
Curr Min Error;
Curr Max Warn;
Curr Min Warn;
Wiring. Warning;
Selection of 1st display line
Notes regarding the measured values Fprt1 to Fprt4 (assignment
of measured values in the submenu Diagnosis / Fingerprint) as
well as the diagnosis error register, see page 97.
Q [Percent]
Display 1st line Devices with PROFIBUS PA, in addition to the following options:
Flow rate in percentage, Physical unit, in m/s, Bar graph,
Totalizer, Totalizer → F, Totalizer ← R, Totalizer diff., Detector
empty tube; have additional options:
PA Addr+State.
The bus address and status of cyclic communication is displayed
(STOP, CLEAR or OPERATE) is displayed.
PA Addr + State
To Next Page
Loading...
