ABB HT580635 - Fig. 47: Removing Cartridge Group 1; Removing the Cartridge Group; Table 41: Tightening Torque (90012-01)

Operation Manual / 4 Product description / A150-M56/66/57/67 -
A155-M..
9 Dismantling and fitting with removed air inlet and gas outlet / 9.6
Removing the cartridge group
© Copyright 2018 ABB. All rights reserved. HZTL4032_EN Revision H July 2018
9.6 Removing the cartridge group
u Mark the casing position for assembly.
Fig.47: Removing cartridge group 1
Position A150-M A155-M
01 150 Nm 150 Nm
Table41: Tightening torque (90012-01)
1. Treat threads of studs (51006) with penetrating oil and leave to take effect.
2. Loosen nuts (51007) and remove Verbus Ripp® washers (51003) together with the fasten-
ing strips (51002).
3. Fit the cross-piece of the service support (90012). Observe the tightening torque.
Page 85 / 161