ABB HT580635 - Fig. 84: Installing the Cartridge Group 2; Table 55: Fitting the Turbocharger, Dimensions X,L; Table 56: Tightening Torque (51007)

Operation Manual / 4 Product description / A150-M56/66/57/67 -
A155-M..
10 Dismantling and fitting, cartridge concept / 10.8 Installing the cart-
ridge group
© Copyright 2018 ABB. All rights reserved. HZTL4032_EN Revision H July 2018
Fig.84: Installing the cartridge group 2
Product Dimension X Dimension L
A150 112 ±2 mm 52 ±2 mm
A155 144 ±2 mm 72 ±2 mm
Table55: Fitting the turbocharger, dimensions X,L
Part number A150 A155
51007 M16
175 Nm
M16
175 Nm
Table56: Tightening torque (51007)
1. Lightly lubricate the hole in the bracket, into which the centering bush (42193) is inser-
ted, with screw grease.
2. If present: Insert the metal C-ring(51105).
3. Move the cartridge group into the turbine casing and align with the markings (M) made
on the bracket at the time of disassembly.
4. Screw clamping nut (42201) upwards to end of threaded rod and insert the centering
bush (42193) into the hole.
Check dimension X (if dimension X is not reached, the turbocharger must be re-aligned).
5. Screw in the threaded rod until value L is reached.
6. Tighten the pressure screws of the clamping nut. (see Tightening pressure screws →18)
7. Secure fastening strips (51002) together with nuts (51007) and Verbus Ripp® washers
(51003).
Page 120 / 161