ABB HT580635 - Stopping the Engine

Operation Manual / 4 Product description / A150-M56/66/57/67 -
A155-M..
5 Operation and service / 5.4 Stopping the engine
© Copyright 2018 ABB. All rights reserved. HZTL4032_EN Revision H July 2018
5.4 Stopping the engine
CAUTION
Residual heat in the turbocharger
If the residual heat in the turbocharger is not adequately dissipated, it may
damage the engine.
u Adequate cooling of the turbocharger must be ensured after stopping
the engine.
u Run the engine for 5 ... 10 minutes at idling speed before stopping it.
u Observe the oil pressure specified for engine idling &.
¡ For oil-cooled bearing casings, post-lubricate for 20minutes if the turbine inlet temper-
ature (t
TE
) exceeds the following values when the engine is stopped:
– 550 °C with insulated casing
– 600 °C with non-insulated casing
At temperatures below the specified values, post-lubrication must be ensured until the
rotors come to a standstill. ABB Turbo Systems recommends post-lubrication for
10minutes.
u Observe the oil pressure specified for post-lubrication &.
Page 38 / 161