HVC 450 kW E-Bus Charger Installation Guide
Revision: 1.2 COMPANY CONFIDENTIAL
Date released: 16-08-2018 Page 67 of 128
5.6.4. Install the protection covers
Preconditions:
Tools: cross-head screwdriver
1. Take the 3 protection covers that was removed in Remove the protection covers on Page
64.
2. Place the protection covers (D) back on the connector blocks (C).
3. Take the protection plate and the screws that were removed in Remove the protection
covers on Page 64.
4. Place the protection plate (A) back over the main switch and connector blocks and
secure the plate by the screws (B).
To Next Page
Loading...
Need help?
General
