NoteAction
Note
There will be some oil left in the gearbox
after draining.
8
Tightening torque:
• 24 Nm
Refit oil plug.
Note
Before refitting the oil plug in the gearbox,
always replace the oil plug sealing washer
with a new one. If not there is a risk of
leakage.
9
Filling oil, axis-2 gearbox
Use this procedure to fill the gearbox with oil.
NoteAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
1
WARNING
Handling gearbox oil involves several safety
risks. Before proceeding, please read the
safety information in the section WARNING
- Safety risks during work with gearbox
lubricants (oil or grease) on page 55.
2
CAUTION
The gearbox can contain an excess of
pressure that can be hazardous. Open the
oil plug carefully in order to let out the ex-
cess pressure.
3
See the figure in:
• Location of oil plugs on page 164
Open oil plug, filling.4
Where to find type of oil and total amount
is detailed in Type and amount of oil in
gearboxes on page 151.
Refill the gearbox with lubrication oil.
Note
The amount of oil to be filled depends on
the amount previously being drained.
5
Continues on next page
166 Product manual - IRB 2600
3HAC035504-001 Revision: G
© Copyright 2009-2015 ABB. All rights reserved.
3 Maintenance
3.4.4 Changing the oil, axis-2 gearbox
Continued
To Next Page
Loading...
