2 Installation and commissioning
2.3.10. Installation of cooling fan for motors, axes 1-3 (option)
3HAC020993-001 Revision: G80
© Copyright 2004-2008 ABB. All rights reserved.
Plate for customer connections, at base
xx0500002301
Additional cabling to and
inside the controller
- Specified in section Position switch and
fan cables, robot base to controller
(option) on page 102.
Locking liquid - Loctite. Used for the three tightening
screws.
Standard toolkit - The contents are defined in section
Standard toolkit on page 388, in part 2 of
the Product manual.
Circuit diagram - See chapter Circuit diagram in the
Product manual, reference information.
Other tools and procedures
may be required. See
references to these
procedures in the step-by-
step instructions below.
These procedures include references to
the tools required.
Equipment Art. no. Note
A Plate for customer connections
B Attachment screws, 3 pcs, M6x16
Continued
Continues on next page
To Next Page
Loading...
