NoteAction
xx1400002172
With base and gearbox safely resting on the
support legs, unscrew the attachment screws
that secure the gearbox to the base, from
underneath the base.
Tip
This procedure is best performed by two
persons working together:
• one underneath the robot base making
sure that the bit is being fitted into the
screw head holes, all the way until they
reach the bottom
• one using the torque wrench, tighten-
ing the screws from beside the base.
8
xx1700001375
Remove the protection tube from the base
by removing the two attachment screws and
pulling the tube downwards.
9
Guide pin, M20x180: 3HAC048814-002Fit two guide pins in opposite holes.
Tip
Lubricate the guide pins with some grease
to make the gearbox slide better.
10
Always use guide pins in pairs.
xx1700000337
CAUTION
The weight of the gearbox is
92 kg (IRB 6700 -235/2.65, -205/2.80,
-175/3.05, -150/3.20, -200/2.60, -155/2.85)
140 kg (IRB 6700 -300/2.70, -245/3.00)
All lifting accessories used must be sized
accordingly.
11
Continues on next page
Product manual - IRB 6700 643
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.8.2 Replacing the axis-1 gearbox (IRB 6700 - 300/2.70, IRB 6700 - 245/3.00)
Continued
To Next Page
Loading...
