Refitting the wrist cover
NoteAction
xx2100002626
Make sure that the cable harness is routed
and secured as shown in the figure.
1
:
Wrist cover:Foundry Plus:2
3HAC074181-002 (Graphite White)Inspect the gasket.
3HAC074181-004 (ABB Orange)Replace the complete cover if the gasket
is damaged.
xx2100001407
Torx pan head screw: M6x16 A4-80Refit the wrist cover and secure with
screws.
3
Tightening torque: 10 Nm.
Foundry Plus:
xx2000000373
Fit all the screws first, then torque tighten.
Concluded refitting of the cable harness
NoteAction
See the product manual for the DressPack.If the robot is equipped with DressPack
cable package:
1
Refit all parts that belong to the DressPack.
Continues on next page
258 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.4.1 Replacing the arm house cover including the axis-4 cassette sealing
Continued
To Next Page
Loading...
