NoteAction
xx2200001614
Remove the guide for the reduction gear.13
xx2200001611
Measure the distance from the edge of the
frame to the radial sealing at three different
locations (same locations as before remov-
ing the arm system).
Compare to the measurements made prior
the arm system was refitted to the base.
Adjust alignment of the sealing if needed.
14
Hex socket head cap screw: M16x50 12.9
Gleitmo 603+Geomet 500
Fit and tighten the accessible attachment
screws to secure the frame to the axis-1
gearbox.
15
Tightening torque: standard torque 300 Nm
(Tightening torque for lubricated screws
(Molykote, Gleitmo or equivalent) with allen
head screws on page 626).
xx2200001421
Continues on next page
462 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.8.1 Replacing the axis-1 gearbox
Continued
To Next Page
Loading...
