DescriptionRevision
Published in release R18.1. The following updates are made in this revision:
• Information added about fatigue to Axis Calibration tool, see Calibration
tools for Axis Calibration on page 362.
• Added sections in General procedures on page 146.
• Safety restructured.
• Updated spare part number brake release board (was DSQC563, is
DSQC1050)
• Added spare part number for axis-2 and axis-3 gearbox o-ring in repair
procedures.
• Note added to calibration chapter to emphasize the requirement of
equally dressed robot when using previously created reference calib-
ration values.
• Information about myABB Business Portal added.
K
Published in release R18.2. The following updates are done in this revision:
• Added locating hole position in tool flange view.
L
Published in release R18.2. The following updates are made in this revision:
• Updated references.
M
Product manual - IRB 760 13
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
Overview of this manual
Continued
To Next Page
Loading...
