Press tool premounting bearing
The press tool used for premounting the bearing race, bearing complete, radial
seal with dustlip and ring in the tilthouse, consists of the parts shown in the figure.
xx1000001431
Note! Parts of the tool cannot be ordered separatly. All parts (except the hydraulic
cylinder) are inluded when ordering the complete tool.
Threaded barA
Stop nutB
Hydraulic cylinder (must be ordered separately)C
Distance (and screws M6x14, 2 pcs)D
Press housing (3HAC039277-004)E
Press washer (3HAC039277-005)F
Continues on next page
196 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.2 Replacing the tilthouse unit
Continued
To Next Page
Loading...
