NoteAction
xx1000001419
Be careful not to damage the ball plug!
Note
Do not remove the ball plug!
9
Remove one shaft at a time by following the
steps below, starting on axis 2 side.
10
xx1000001072
Use compressed air in the M6 hole for filling
grease, in order to remove the VK cover. Do
this on both sides.
Put a hand with some paper over the VK cover
in order to catch it.
CAUTION
Only a very low air pressure is needed!
11
Parts:
A Screw M6x10 quality steel 8.8-
A2F
B Washer
Continues on next page
Product manual - IRB 760 201
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.2 Replacing the tilthouse unit
Continued
To Next Page
Loading...
