NoteAction
xx1000001438
Push the shaft of the axis 3 side into its hole,
from the inside.
6
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Push the torsion bar L=650 through the hole in
the shaft.
7
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Fit the stop nut behind the shaft.8
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Place the support housing on the outside of the
shaft.
9
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Thread the race of the remaining bearing com-
plete facing the outside of the tilthouse, on the
press housing of the press tool, mounting axis
6 and fit it on the shaft.
10
Shown in the figure Press tool as-
sembly/disassembly axis 6 on
page 197.
Art. no. is specified in Required
equipment on page 195.
Art. no. is specified in Required
equipment on page 195.
Fit the hydraulic cylinder of the press tool,
mounting axis 6 from the outside of the tilt-
house. Secure the parts with the stop nut.
11
Shown in the figure Press tool as-
sembly/disassembly axis 6 on
page 197.
Continues on next page
208 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.2 Replacing the tilthouse unit
Continued
To Next Page
Loading...
